By Cyrielle Marjolaine. Power. Publised at Tuesday, December 19th 2017, 11:49:21 AM. The control circuitry must monitor (sense) the output voltage, and adjust the current source (as required by the load) to hold the output voltage at the desired value. The design limit of the current source defines the maximum load current the regulator can source and still maintain regulation.
By Bertille Solange. Motor. Published at Friday, February 09th 2018, 05:54:45 AM. Eddy current and hysteresis heating are collectively called iron losses. The former induces currents in the iron of the motor while the latter is caused by the re-alignment of the magnetic domains in the iron. You can think of this as “friction heating” as the magnetic dipoles in the iron switch back and forth. Either way, both cause the bulk heating of the motor. Iron losses are a function of AC current and therefore the power supply voltage.
By Sasha Sara. Car Wiring. Published at Friday, February 09th 2018, 01:15:05 AM. Modern cars often need room for many wires in confined spaces. Some manufacturers now use printed circuits instead of bundles of wires, particularly at the rear of the instrument panel. Printed circuits are plastic sheets on which copper tracks have been "printed". Components are plugged directly into the tracks. A few modern cars have flexible printed circuits. The copper tracks are printed in ribbons of flexible plastic, which replace the whole wiring system.
By Sasha Sara. Car Wiring. Published at Friday, February 09th 2018, 00:03:30 AM. The starter motor has its own heavy cable, direct from the battery. The ignition circuit furnishes the high-tension impulses to the sparkplugs; and the charging system includes the generator, which recharges the battery. All the other circuits are called ancillary (subsidiary) circuits.
By Alix Loane. Motor. Published at Monday, January 29th 2018, 23:13:59 PM. An ideal step motor would have zero mechanical friction, its torque would be proportional to ampere-turns and its only electrical characteristic would be inductance. Ampere-turns simply mean that torque is proportional to the number of turns of wire in the motor’s stator multiplied by the current passing through those turns of wire.
By Madeleine Catherine. Motor. Published at Monday, January 29th 2018, 18:05:09 PM. The power output decreases with speed because of the constant-torque loss due to detent torque and other losses. The same effect causes a slight decrease in torque with speed in the constant torque region as well. Finally, there is a rounding of the torque curve at the corner speed because the drive gradually transitions from being a current source to being a voltage source. The drive limits current to the motor below the corner speed and thus is a current source. Above the corner speed, the motor’s inductive reactance limits the current and the drive becomes a voltage source as it applies all of the power supply voltage to the motor.
By Charlotte Myriam. Car Wiring. Published at Sunday, January 28th 2018, 14:00:15 PM. The most common type of fuse is a short length of thin wire enclosed in a heatproof casing often glass. The size of the fuse wire is the thinnest that can carry the normal current of the circuit without overheating, and it is rated in amps.
By Madeleine Catherine. Car Wiring. Published at Friday, January 26th 2018, 20:43:45 PM. The same is true of the ignition wire and the coil wire. These should not be closer than 1 inch. Many teams will tie-wrap these two wires together, which is a very bad idea. The pulse from the coil wire is very strong and interferes with the ignition signal.
Altrushare - Wiring Diagram Gallery
Copyright © 2003 - 2018 Domain Media. All sponsored products, company names, brand names, trademarks and logos arethe property of their respective owners.