By Sasha Sara. Power. Publised at Monday, December 18th 2017, 20:48:32 PM. The output resistance (also known as source resistance) of a voltage regulator is a close cousin of its load regulation. Figure 1 illustrates how the output voltage of a regulator typically changes as a function of load current. Initially, the slope is quite linear but once the load current becomes higher than the design then the voltage will often drop rapidly with an increase in current. We measure the output resistance only on the linear portion of the plot in the normal operating region. It is meaningless to use a point in the overload area as that will result in an artificially high output resistance.
By Sasha Sara. Circuit. Published at Saturday, December 16th 2017, 23:35:56 PM. Double-layer or double-sided PCBs have a base material with a thin layer of conductive metal, like copper, applied to both sides of the board. Holes drilled through the board allow circuits on one side of the board to connect to circuits on the other.
By Sasha Sara. Circuit. Published at Saturday, December 16th 2017, 23:20:56 PM. The real part and imaginary part of impedance are interpreted as a resistive part that dissipates energy and a reactive part that stores energy. Resistors can only dissipate energy and therefore their impedances have only a real part. Capacitors and inductors can only store energy and therefore their impedances have only an imaginary part. When resistors, capacitors, and inductors are combined, the overall impedance may have both real and imaginary parts. It is important to note that the definition of impedance preserves the definition of resistance.
By Alix Loane. Circuit. Published at Saturday, December 16th 2017, 19:28:35 PM. Since single-layer/single-sided PCBs only have their various circuits and electrical components soldered onto one side, they are easy to design and manufacture. This popularity means that they can be purchased at a low-cost, especially for high-volume orders. The low-cost, high volume model means they are commonly used for a variety of applications, including calculators, cameras, radio and stereo equipment, solid state drives, printers and power supplies.
By Cyrielle Marjolaine. Diagram. Published at Saturday, December 16th 2017, 16:52:58 PM. In addition to reading this instructable it may be a good idea for you to read my other instructable "electronics components and what they do" to get a good understanding of what you are doing when building a project.
By Cyrielle Marjolaine. Circuit. Published at Saturday, December 16th 2017, 16:15:18 PM. A capacitor is a device that stores energy in the form of voltage. The most common form of capacitors is made of two parallel plates separated by a dielectric material. Charges of opposite polarity can be deposited on the plates, resulting in a voltage V across the capacitor plates. Capacitance is a measure of the amount of electrical charge required to build up one unit of voltage across the plates.
By Lydie Honorine. Power. Published at Saturday, December 16th 2017, 16:09:24 PM. The lower dropout voltage is the reason LDO regulators dominate battery-powered applications, since they maximize the utilization of the available input voltage and can operate with higher efficiency. The explosive growth of battery-powered consumer products in recent years has driven development in the LDO regulator product line.
By Madeleine Catherine. Circuit. Published at Saturday, December 16th 2017, 14:21:35 PM. In the hydrodynamic analogy of electronic circuits, resistors are equivalent to a pipe. As fluid flows through a pipe, frictional drag forces at the walls dissipate energy from the flow and thus reducing the pressure, or equivalently, the potential energy of the fluid in the pipe. A small resistor is equivalent to a large diameter pipe that will allow for a high flow rate, whereas a large resistor is equivalent to a small diameter pipe that greatly constricts the flow rate.
Altrushare - Wiring Diagram Gallery
Copyright © 2003 - 2018 Domain Media. All sponsored products, company names, brand names, trademarks and logos arethe property of their respective owners.